Typical needs
- Full material traceability and 3.1 certificates
- FAI and CMM dimensional reports
- Production tooling, jigs and fixtures
- Recurring short runs of machined parts
Parts and sub-assemblies for the aerospace sector, made in Morocco
Around Casablanca (Midparc, Nouaceur), Morocco's aerospace cluster brings together EN 9100 certified machining, sheet metal and surface treatment shops. DSSF CONNECT draws on these shops for precision parts, production tooling and short runs, with material and document traceability matching supply chain expectations.
Specific requirements (certified grades, approved special processes, FAI per AS9102) are stated in the request and condition assignment. No flight part is committed without engineering review and customer validation.
Aerospace
Typical parts
- 5-axis machined aluminium and titanium parts
- Assembly tooling and drill jigs
- Precision sheet metal parts and brackets
- Precision turned parts
- Test bench components
Processes
Processes involved
Most requested processes for this sector in the DSSF CONNECT network.
- Assisted quoting
CNC milling
3 to 5 axis, prototypes and series, tolerances down to ±0.02 mm depending on shop.
View page - Assisted quoting
CNC turning
Turned parts, mill-turn, precision bar turning.
View page - Assisted quoting
Sheet metal: cutting + bending
Bent, welded and assembled parts, paint and zinc finishes.
View page - Manual quote
Investment casting
Precision lost-wax casting: steels, stainless, superalloys, bronze; complex geometries.
View page - Assisted quoting
3D printing SLS
PA12, glass-filled PA12, support-free end-use parts.
View page - Manual quote
Finishing and treatments
Anodising, powder coating, zinc plating, galvanising, heat treatment: on supplied parts or parts made by the network.
View page
Capacities, series and lead times shown are orders of magnitude matching the network target; they are confirmed on each quote according to the selected shop. No prices are displayed on these pages.
Frequently asked questions
- Are the shops EN 9100 certified?
- Part of the network is; certification is a mandatory assignment criterion when the request specifies it.
- Do you perform approved special processes?
- Surface and heat treatments are subcontracted to shops whose approvals are checked case by case; state the required standards (Nadcap, OEM approvals).
- Do you provide an FAI?
- Yes, per AS9102, as a quote option, with CMM dimensional report.
- Can you machine titanium and Inconel?
- Yes, at equipped shops; these materials are subject to material sourcing and a manual quote.